MORRISON BROS. Morrison Bros. 710SS Series 3 in. Stainless Steel Anti-Siphon Solenoid Valves w/ FKM Seal - Threaded 710SS-0300 1V

3-Inch Stainless Steel Normally Closed Solenoid Valve for High-Flow Fuel, Chemical & Liquid Cooling Applications The Morrison Bros. 710SS in 3" NPT is the largest threaded configuration in the 710SS series, engineered for high-volume flow isolation with a CV of 93.60 and a maximum operating pressure of 45 PSI. The lower pressure rating relative to smaller sizes reflects the hydraulic realities of large-bore piping. At 3", this valve is best suited for main facility fluid headers, large CDU primary loop connections, bulk chemical transfer, or petroleum product pipelines where flow capacity takes priority over high-pressure service. In data center liquid cooling, the 3" size is typically specified at the facility infrastructure level: primary coolant mains, thermal plant connections, or large immersion cooling system supply headers where high flow with minimal restriction is called for. The aluminum piston on the 3" model (versus stainless steel on 1"–2" sizes) is worth noting for engineers specifying immersion or corrosive fluid service. Be sure to confirm fluid compatibility for that wetted component. The 304 SS body and PTFE seals remain standard, providing the same corrosion resistance and chemical inertness for glycol, DI water, and dielectric fluid circuits as the smaller sizes. Power consumption increases to 48 watts at 3", and the valve requires the same horizontal pipeline, upright vertical installation as all 710SS models. The integral thermal relief and zero pressure differential hung-piston design also carry through to this size. Key specifications: Size: 3" NPT Body: 304 stainless steel Seals: PTFE Piston: Aluminum Orifice: 3" CV: 93.60 Operating pressure differential: 0–45 PSI Max fluid temperature: 302°F Min operating temperature: -40°F Power consumption: 48 watts Coil: Continuous duty Class H, 120V AC standard (multiple voltages available) Enclosure: Watertight, explosion-proof — NEMA 3, 4X, 7, 9; Groups C and D Max fluid viscosity: 60 centistokes Certifications: UL/cULus Listed; Class I Div. 1 Groups C&D; Class II Div. 1 Groups E, F, G; Class III Install orientation: Horizontal pipeline, upright vertical position NOTE: Product can only be pumped in one direction, the direction of the flow arrow. Not designed for use as an overfill prevention or process control valve. Features Normally closed, hung piston design Install in a horizontal pipeline in the upright vertical position Zero pressure differential Integral thermal relief allows the valve to relieve expansion pressure in the opposite direction of flow Continuous duty Class H standard coil operates at 120 volts Several optional coil voltages available Enclosure is watertight and rated for hazardous locations—NEMA 3, 4X, 7 and 9; groups C and D Recommended for use with liquids having a maximum viscosity of 60 centistokes A strainer with a 100 mesh screen is recommended at the valve inlet Construction Details Body: Stainless steel Seals: Viton®, Teflon® Solenoid housed in an integral, watertight, explosion-proof shell Certifications CSA approved for hazardous locations Class I, Groups C and D Class II, Groups E, F and G Class III • T3C