OPW High Flow Nozzles 295SC

Spout not included.295SC Right angle design, dual poppets, replaceable hold-open rack, adjustable dash pot to minimize line shock, built-in swivel and check valve. With aluminum body and 3-position hold open device. Built in swivel and check valve. Insulated lever! Features Aluminum body - lighter weight, easier to maneuver. Dual poppets - easy to open nozzle against high inlet pressures. Replacement hold-open rack - one-hand control of hold-open mechanism means easy setting of flow speed. Nozzle must be attended at all times during usage. Replaceable composite lever guard - easy, low cost replacement should the guard be broken. Right angle design - provides larger lever area for better grip and easier control; permits nozzle to fit into awkward spaces close to walls and into corners. Adjustable dash pot - permits adjusting the main poppet closure rate over a wide range of flows to overcome line shock with minimum afterflow. Built-in swivel - eliminates twisting and kinking of the hose. This swivel is hard coated aluminum and has full bearing surfaces. Built-in check valve - prevents hose drainage after pump is turned off. Vinyl coated lever - insulates fingers against cold. Easily replaced spout - the spout is easily threaded into the body. Replacement spouts are readily  available from OPW. NPT female threads at inlet end - standard pipe threads accept all 1 1/4 or 1 1/2" male connections. Design working pressure - OPW nozzles are designed to work at 50 PSI maximum pressure. Caution IMPORTANT: OPW products should be used in compliance with applicable federal, state, provincial, and local laws and regulations. Product selection should be based on physical specifications and limitations and compatibility with the environment and materials to be handled. OPW MAKES NO WARRANTY OF FITNESS FOR A PARTICULAR USE. Materials Body: cast aluminum Main Stem: stainless steel Stem Seal: Nitrile Rubber O-ring Main Poppet Disc: Viton® Spout: OPW 297 aluminum (optional)